Martin Audio ENGINEER Guía de usuario descargar pdf (Pagina 62)

Engineer 418 & 818 User Manual Page 62

Controlling the Basscreator

To start using the Basscreator you should first route the inputs you want to use it on toward the Basscreator

module in the Routing tab. Then select the Basscreator tab to control its settings.

First, select the frequency you want to set as the perceived bass. The best value for this setting depends on the

genre of music you'll be playing most regularly and the size of you speaker system.

A rule of thumb for this is to choose the frequency about one octave below the low cut-off of your speaker.

This means that if you have a speaker which is capable of producing 100 Hz, you should use the 50HZ setting

one the Basscreator as a starting point.

If you have set the frequency, set the drive and mix levels. The drive level determines the amount of

harmonics generated by the algorithm and determines the sound it will produce for a large part. The mix level

sets the amount of added effect (the amount of virtual bass added to the original signal).

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 79 80

Sin comentarios

Martin Audio ENGINEER Guía de usuario Pagina 62